HP S10 Bedienungsanleitung PDF herunterladen (Seite 72)

70 LED Indicators

LED Indicators

Table 2 LED Indications

Label

LED Pattern

and Color Indication Possible Causes

Power steady – green Hub is powered on. Normal state

flashing - green Power is intermittent. – Fibre Channel Manager is set to beacon

(flash) the Power LED (normal state).

– Line voltage is inadequate.

– Hub is faulty.

blank – off No power to hub. – Line has no voltage.

– Hub is disconnected, or power cable is bad.

– Hub is faulty.

Fault steady – amber Hub is running self-test.

If light remains on after

20 seconds, hub failed

self-test.

If self-test fails, hub detected either:

– A faulty fan module

– A faulty hub

blank – not on Self-test completed or

power is off. (Power

LED is also off.)

Normal running or off state

Ports

1-10

steady – green FC-AL connection to

this port is valid.

Normal state for a connected port

blank – not on Port for this LED is

inactive.

Port is being bypassed because:

– Port is not connected to another device.

– Port was bypassed in Fibre Channel

Manager.

– Attached FC-AL device is faulty or turned

off.

– Port is faulty.

– Cable or connector is faulty.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 133 134

Keine Kommentare

HP S10 Bedienungsanleitung Seite 72