HP S10 Bedienungsanleitung PDF herunterladen (Seite 28)

26 Procedure 3: Verify Hub Operation

4. Verify that the 10Base-T port is operating properly. Insert an ethernet cable that is

connected to the LAN into the 10Base-T port, and verify that the 10Base-T status LED

turns on. (The status LED may begin flashing.)

5. Set the hub IP address and configure the hub as described in chapter 3, RS-232 Interface

Functions.

6. Verify the connection between the HP-UX server and the hub. At the management server

where Fibre Channel Manager is or will be installed, execute the following command:

/etc/ping <hub IP address> Example: /etc/ping 15.43.214.13

Fibre Channel Manager requires HP-UX 10.20 or 11.0 on the management server.

If you are unable to ping the hub, refer to If the Management Server Cannot Ping the

Hub on page78.

7. Unplug the hub.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 133 134

Keine Kommentare

HP S10 Bedienungsanleitung Seite 28