Hp TC4100 Bedienungsanleitung PDF herunterladen (Seite 90)

Chapter 6 Troubleshooting

2. Move switch 4 in the configuration switch on the system board (labeled "Clear CMOS") to the ON position.

Figure 6-1. Configuration Switch Settings

3. Turn on the power to the HP server. A message displays indicating the configuration has been cleared.

4. Turn off power to the HP Server.

5. Return switch 4 on the system board to the OFF position.

6. Close the side panel.

7. Turn on the power to the HP server and the following message displays:

Incorrect System Configuration

8. Press F2 to run the BIOS Setup Utility.

9. Make any configuration changes required.

10. Choose the Exit option and save the changes to save the configuration and exit the Setup Utility.

Password Problems

The only way to resolve the issue of a forgotten Supervisor password is to clear the password by using the

appropriate dipswitch on the system board. Refer to the appropriate HP Server Operation and Maintenance

Guide for the location of the password dipswitch.

Supervisor Password

1. Power off the HP Server. Remove the covers and locate the password dipswitch and move to the opposite

position.

Table 6-2. Configuration Switch Block

Switch Number Switch On Switch Off

1 Not Used Not Used

2 Not Used Not Used

3 Clear Password Keep Password

4 Clear CMOS Keep CMOS

5 Not Used Not Used

6 Not Used Not Used

7 Not Used Not Used

8 Not Used Not Used

pen =

Closed = On

Shaded rectangle

represents the

position of slide switch

OPEN

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 129 130

Keine Kommentare

Hp TC4100 Bedienungsanleitung Seite 90