Hp TC4100 Bedienungsanleitung PDF herunterladen (Seite 115)

113

Chapter 7 Replacing Parts

13. The System Board assembly is secured to the chassis by four blue thumbscrews. Two of these screws are

on the System Board assembly and closest to the front of the server. The other two thumbscrews are at the

rear of teh server inside the chassis.

14. Loosen the four captive thumbscrews. See .Figure 7-12

Figure 7-12. Captive Screw Locations

15. Slide the system board towards the front of the system until it stops (approximately 1/2 inch).

16. Using the thumbscrews closest to the top of the server (pedistal model) or right side of the server (rack-

mount model), pull up and out to remove the System Board assembly out of the chassis.

Installing the System Board Assembly

1. Install the new System Board on the System Board assembly.

WARNING

6 5 4 3

0123

2 1

1 2 3 4 5

Warning Label Tray keySlot

(

9 Places

)

Captive

Thumb

Screws

Captive

Thumb

Screws

Standoff

(2 Places)

Screw

(6 Places)

Front of

System

Rear of

System

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 129 130

Keine Kommentare

Hp TC4100 Bedienungsanleitung Seite 115