Hp ProLiant DL380 Server Bedienungsanleitung Seite 13
- Seite / 128
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Component identification 13
Item Description Status
1
UID LED/button Off = Deactivated
Solid blue = Activated
Flashing blue = System being managed remotely
2
Power supply 2
LED
Off = System is off or power supply has failed.
Solid green = Normal
3
Power supply 1
LED
Off = System is off or power supply has failed.
Solid green = Normal
4
NIC activity LED Off = No network activity
Solid green = Link to network
Flashing green = Network activity
5
NIC link LED Off = No network link
Green = Network link
Non-hot-plug PCI riser board slot definitions
• Primary riser cage connector, connected to processor 1 or the southbridge
PCIe 3-slot riser cage* PCIe 2-slot x16 riser cage
1 - FL/FH
PCIe2 or PCIe3** x16 (16,8,4,2,1) —
2 - HL/FH
PCIe2 or PCIe3** x8 (8,4,2,1) —
3 - HL/FH
PCIe2 x8 (4,2,1)† —
• Secondary riser cage connector, connected to processor 2 (Processor 2 must be installed)
PCIe 3-slot riser cage* PCIe 2-slot x16 riser cage
4 - FL/FH
PCIe2 or PCIe3** x16 (16,8,4,2,1) PCIe2 or PCIe3** x16 (16,8,4,2,1)
5 - HL/FH
PCIe2 or PCIe3** x8 (8,4,2,1) PCIe2 or PCIe3** x16 (16,8,4,2,1)
6 - HL/FH
PCIe2 or PCIe3** x8 (8,4,2,1) —
*The server ships with one PCIe3 riser cage installed in the primary riser cage connector.
**These slots can run 8 GT/s signaling rate in either PCIe2 or PCIe3 mode, depending on the capability of
the installed processor.
†PCIe slot 3 is connected to the southbridge and runs at the Gen2 signaling rate.
Notes:
• "Primary" denotes the riser cage is installed in the primary riser connector.
• "Secondary" denotes the riser cage is installed in the secondary riser connector.
• Installing the riser cages listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those riser cages.
• FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs and buttons 8
- Item Description Status 9
- Press and release the panel 9
- Systems Insight Display LEDs 10
- Rear panel components 12
- Rear panel LEDs and buttons 12
- System board components 14
- System maintenance switch 15
- NMI functionality 16
- DIMM slot locations 16
- SAS and SATA device numbers 17
- PCI riser cage LED 17
- Hot-plug fans 19
- Component identification 20 20
- Operations 21
- Remove the access panel 22
- Install the access panel 23
- Remove the hot-plug fan cage 24
- Remove the hot-plug fan 25
- Install the PCI riser cage 27
- Remove the air baffle 29
- Rack planning resources 31
- Optimum environment 31
- Temperature requirements 32
- Power requirements 33
- Rack warnings 34
- Installing hardware options 35
- Registering the server 38
- Introduction 39
- Processor and fan option 39
- Install the heatsink 44
- Remove the two fan blanks 44
- Memory options 46
- HP SmartMemory 47
- DIMM identification 48
- Memory configurations 49
- Installing a DIMM 51
- Hot-plug hard drive options 52
- Controller options 54
- Optical drive option 58
- FlexLOM option 61
- Expansion board options 63
- Hard drive cage option 68
- Remove the fan cage 70
- 13. Connect the cables: 72
- Install the fan cage 75
- Install the air baffle 75
- 2U rack bezel option 77
- 7. Reboot the server 81
- Cabling 82
- Optical drive cabling 83
- FBWC cabling 84
- Chipset SATA cable option 85
- 150W PCIe power cable option 88
- Server mode 89
- Server QuickSpecs 89
- HP iLO Management Engine 89
- Active Health System 90
- Intelligent Provisioning 91
- Erase Utility 92
- HP Service Pack for ProLiant 93
- HP ROM-Based Setup Utility 94
- Boot options 95
- Configuring AMP modes 95
- Utilities and features 96
- ROMPaq utility 97
- Automatic Server Recovery 98
- USB support 98
- Redundant ROM support 98
- Keeping the system current 99
- ProLiant Servers 100
- Troubleshooting 101
- Battery replacement 102
- FCC rating label 103
- Modifications 104
- • EMC Directive 2004/108/EC 105
- BSMI notice 106
- Korean notice 106
- Japanese notice 106
- Chinese notice 107
- Laser compliance 107
- Battery replacement notice 107
- Electrostatic discharge 109
- Specifications 110
- Specification Value 113
- Technical support 114
- Technical support 115 115
- Customer Self Repair 116
- Technical support 117 117
- Reparo feito pelo cliente 118
- Technical support 119 119
- Technical support 120 120
- Technical support 121 121
- Acronyms and abbreviations 122
- Documentation feedback 125
- Index 126 126
- Index 127 127
- Index 128 128
Verwandte Produkte und Handbücher für Computerhardware Hp ProLiant DL380 Server
(88 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.184 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern