Hp NonStop G-Series Bedienungsanleitung PDF herunterladen (Seite 97)

Switch Command Interface (SWCI)

ServerNet Nomadic Disk (Release 2) User’s Guide—523968-001

6-27

Application Initialization Error Messages

Cause. SWCI could not successfully access its startup message to obtain file

input/output parameters.

Effect. SWCI stops.

Recovery. Restart SWCI.

Cause. The switch module device specified for SWCI is a terminal device (device type

6), but not an asynchronous serial port (subtype 0).

Effect. SWCI stops.

Recovery. Check that you have specified a valid switch module device name. Check

the configuration of the WAN profile that specifies the device subtype. If the PROFILE

specifies a wrong device subtype, reconfigure the switch module device with the

correct device subtype. Then, restart SWCI.

Cause. The switch module device specified for SWCI is not a terminal device (device

type 6).

Effect. SWCI stops.

Recovery. Check that you have specified a valid switch module device name. Check

the configuration of the WAN profile that specifies the device type. If the PROFILE

specifies a wrong device type, reconfigure the switch module device with the correct

device type. Then, restart SWCI.

Cause. The TACL RUN command used to start SWCI is incorrectly specified; this

message displays the correct command syntax.

Effect. SWCI stops.

Recovery. Retry the TACL RUN command with the correct syntax.

Startup message not found.

Switch comm port switch-comm-port-name: invalid device

subtype.

Switch comm port switch-comm-port-name: invalid device type.

Usage: $SYSTEM.SYSnn.SWCI switch-comm-port-name.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 147 148

Keine Kommentare

Hp NonStop G-Series Bedienungsanleitung Seite 97