Hp NonStop G-Series Bedienungsanleitung PDF herunterladen (Seite 115)

Switch Command Interface (SWCI)

ServerNet Nomadic Disk (Release 2) User’s Guide—523968-001

6-45

Switch Protocol Error Messages

Recovery. Do the following:

1. Check the configuration of the switch module device and reconfigure if necessary.

2. Check the version of SWCI installed.

3. Power the switch module device off then back on again.

Cause. The response message type received from the SCC for a switch command is

not valid for the type of switch command sent. The type may be any of the following:

Effect. SWCI does not work properly.

Recovery. Do the following:

1. Check the configuration of the switch module device and reconfigure if necessary.

2. Check the version of SWCI installed.

3. Power the switch module device off then back on again.

Cause. The response message received from the SCC in response to a switch

module temperature query does not contain valid temperature data.

Effect. SWCI does not work properly.

Recovery. Do the following:

1. Check the configuration of the switch module device and reconfigure if necessary.

2. Check the version of SWCI installed.

3. Power the switch module device off then back on again.

***PROTOCOL ERROR*** SCC response message: unexpected

response type.

ALARM FIR MUTEALARM REMOTE TEMP2

CROSSED LOCAL PONERROR STRAIGHT UNLOCK

EMPTY LOCK PONOK TEMP1 VOLTS

***PROTOCOL ERROR*** SCC response message: invalid

temperature data.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 147 148

Keine Kommentare

Hp NonStop G-Series Bedienungsanleitung Seite 115