Hp OneView for VMware vCenter Bedienungsanleitung PDF herunterladen (Seite 70)

7. Enter the following information:

• New Datastore Names: Enter the base name for the new datastores. The # symbol is

required and represents the numeric sequence for the new datastore names. In the

generated datastore names, the # symbol is replaced with a number.

• Where # is numeric and starts at: Enter the start value for the numeric sequence of datastore

names. The default values are as follows:

Default start value for numeric sequenceNumber of datastores to add

11–9

0110–99

001100–999

The Generated Names box shows the names of the datastores that will be created.

8. Click Next.

The Create Datastores – Review and Validate window opens. See Figure 38 (page 70).

Figure 38 Create Datastores – Review and Validate window (before validation)

9. Click Next to validate that it is possible to create the datastores.

The Review and Validate window is updated with icons showing the success or failure of the

validation processes.

A green icon indicates success, and a red icon indicates failure. If a validation step fails, a

message is displayed in the Warning and Validation Results box. Correct the problem, and

then click Retry to repeat the validation step. If you need to change values entered in the

wizard, use the Back and Next buttons to navigate.

70 Provisioning storage

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 106 107

Keine Kommentare

Hp OneView for VMware vCenter Bedienungsanleitung Seite 70