9-29
Cisco NAC Appliance - Clean Access Manager Configuration Guide
OL-28003-01
Chapter 9 Configuring Cisco NAC Appliance for Agent Login and Client Posture Assessment
Setting Up Agent Distribution/Installation
Note SwissTimeout works only for UDP SWISS Timeouts.
Refer to the “Configuring the CAS Managed Network” chapter of the Cisco NAC Appliance - Clean
Access Server Configuration Guide, Release 4.9(x) for details.
Table 9-7 Additional SWISS Discovery Customization
Parameter
Default
Value
(Decimal)
Valid
Range Description/Behavior
SwissTimeout 1 > 1
• If this setting is 1, the Agent performs SWISS
discovery as designed and no additional response
packet delay timeout value is introduced.
• If the setting is an integer greater than 1, the Agent
waits the additional number of seconds for a
SWISS discovery response packet from the Clean
Access server before sending another discovery
packet to be sure network latency is not delaying
the response packet en route.
DisableL3SwissDelay 0 0 or 1 If this setting is 1, the Agent disables its ability to
increase the transmission interval for Layer 3 discovery
packets. Therefore, the Layer 3 discovery packets
repeatedly go out every 5 seconds, just like Layer 2
packets. The default setting for is 0 (enabled).
For more information, see the “Layer 3 SWISS Packet
Delay to Conserve Bandwidth” section of the Cisco
NAC Appliance - Clean Access Server Configuration
Guide, Release 4.9(x).
Kommentare zu diesen Handbüchern