HP P6350 Bedienungsanleitung PDF herunterladen (Seite 133)

Table 22 iSCSI or iSCSI/FCoE module secret settings

MS Initiator secret settingsiSCSI or iSCSI/FCoE module secret settings

Setting (example)ActionSetting (example)Source

N/AGeneral Tab SecretN/AiSCSI Port

CHAPsecret01Add Target PortalCHAPsecret01Discovered iSCSI Initiator

CHAPsecret01Log on to TargetN/AiSCSI Presented Target

NOTE: These are examples of secret settings. Configure CHAP with settings that apply to your specific network

environment.

1. Enable CHAP for the iSCSI or iSCSI/FCoE modules discovered iSCSI Initiator entry. CHAP

can be enabled via CLI only. To enable CHAP for the iSCSI or iSCSI/FCoE modules discovered

iSCSI Initiator entry using the iSCSI or iSCSI/FCoE module's CLI:

a. If the iSCSI Initiator is not listed under set chap command:

• HP Command View Option: add the initiator iqn name string via HP Command

View’s add host tab.

• Go to the HP P6000 Command View and select Hosts then select Add Host tab

and enter the iqn name string.

• CLI Option: Enter the initiator add command and add the iSCSI Initiator that is about

to do discovery.

b. If the iSCSI Initiator is listed under set chap command, then enable CHAP secret. For

example: CHAPsecret01:

• Select the index of the iSCSI Initiator.

• To Enable CHAP, select 0, then type the CHAP secret.

Set up the iSCSI Initiator 133

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 315 316

Keine Kommentare

HP P6350 Bedienungsanleitung Seite 133