HP ProLiant Generation ML310 Spezifikationen PDF herunterladen (Seite 31)

Removal and replacement procedures 31

3. Remove the hard drive.

To replace the component:

1. Slide the drive into the cage until it clicks, locking the drive into place.

2. Close the lever.

IMPORTANT: When the drive is inserted, the drive LEDs flash for 2 seconds to indicate that the

drive is seated properly and receiving power.

3. As the drive begins to spin, be sure that the drive LEDs illuminate one at a time and then turn off

together to indicate that the system has recognized the new drive.

4. In fault-tolerant configurations, allow the replacement drive to be reconstructed automatically with

data from the other drives. While reconstruction is in progress, the online LED flashes.

Power button/LED cable

To remove the component:

1. Power down the server (on page 26).

2. Remove the bezel ("Bezel" on page 27).

3. Remove the access panel ("Access panel" on page 28).

4. Remove the media drive in the bottom bay, if necessary ("SATA optical drive" on page 34).

5. Disconnect the power button/LED cable from the system board ("System board components" on

page 68).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Keine Kommentare

HP ProLiant Generation ML310 Spezifikationen Seite 31