HP SP400 Betriebsanweisung PDF herunterladen (Seite 26)

Operate the All-in-One

NOTE: There are two ways to clear the bar code or symbol and prepare the All-in-One to scan again:

• Press the yellow CLEAR button. The red tail lights will flash once and the All-in-One will emit a

tone.

• Wait for the All-in-One to time out and erase the scan from the memory. The All-in-One will

emit a Hi-Lo tone and the red tail lights will flash once.

Scan instructions – Handle configuration

The All-in-One can scan most one-dimensional and two-dimensional bar code symbologies. See

“All-in-One Specifications” for a complete list.

1. Choose either Auto or Manual mode by selecting the switch on the back of unit.

NOTE: If in Manual mode the trigger on the front of the handle must be used to turn on the

scanner

2. Aim the green light bar at the bar code. If in manual mode the trigger must be held down.

3. Hold the All-in-One 6 - 9 inches from the bar code.

4. Hold the All-in-One at a slight angle (approximately 5 degrees) to the scan surface.

NOTE: Hold steady for best results.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Keine Kommentare

HP SP400 Betriebsanweisung Seite 26