HP Ink Tank 310 Bedienungsanleitung PDF herunterladen (Seite 14)

● The Error icon, both Printhead icons, and the Printhead Alert light are blinking.

Cause Solution

One of the following might have occurred.

– Both printheads are missing.

– Both printheads are installed incorrectly.

– Both printheads still have orange plastic tapes or plugs

on them.

– Both printheads are incompatible or damaged.

– If there are no printheads installed in the printer, install

the printheads.

– If both printheads are installed in the printer, remove the

printheads, make sure there is no plug or plastic tape on

them, and then reinsert the printheads securely.

NOTE: After you have set up the printer, do not open

the printhead latch unless installing new printheads or

moving the printer outside your home or oice.

– Make sure that you are using the correct HP printheads

for your printer.

– If the error persists, contact HP Support for help.

Printhead priming and alignment icons

Printheads ready for priming

● The Number of copies icon changes to a blinking P during initial printer setup. At the same time all other

icons on the control panel display are turned o.

Cause Solution

During initial setup, the printer detects that the new

printheads are installed and the ink system is ready for

priming.

Make sure all ink tanks are lled above the minimum line, and

the printhead latch is closed rmly. Press and hold the

Resume button ( ) for three seconds to start ink priming.

NOTE: Priming will occur in the background and will not

block printing, copying, or scanning.

Alignment status icon

● The Number of copies icon becomes a blinking A.

ENWW Control panel lights and display icons status 9

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 97 98

Keine Kommentare

HP Ink Tank 310 Bedienungsanleitung Seite 14