HP Ink Tank 310 Bedienungsanleitung PDF herunterladen (Seite 10)

Get to know the ink tank system

Term Denition

Printheads The printheads are the components in the print mechanism that apply ink to the paper. There are two

printheads: a black ink printhead and a tri-color ink printhead.

NOTE: After you have set up the printer, do not open the printhead latch unless installing new printheads

or moving the printer outside your home or oice.

Printhead latch The printhead latch on the carriage secures the printheads in the carriage. Make sure the printhead latch is

properly closed to avoid problems such as carriage jams.

NOTE: After you have set up the printer, do not open the printhead latch unless installing new printheads

or moving the printer outside your home or oice.

Ink tanks Ink tanks are external ink reservoirs located at the right side of the printer. There are four ink tanks. Each

ink tank corresponds to an individual color: black, cyan, magenta, and yellow.

Ink tank caps Ink tank caps are rubber plugs that seal each ink tank.

Priming Priming is the process of lling the ink supply tubes that run between the ink tanks and the printheads.

This process occurs when you install new printheads and start the priming process from the control panel.

For more information about priming, see Printhead priming and alignment icons on page 9.

Alignment Alignment is a process of aligning the printheads to improve print quality. For more information about

alignment, see Printhead priming and alignment icons on page 9.

ENWW Get to know the ink tank system 5

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 97 98

Keine Kommentare

HP Ink Tank 310 Bedienungsanleitung Seite 10