HP HP ProCurve Series 6600 Spezifikationen PDF herunterladen (Seite 54)

2-30

Installing the Switch

Installation Procedures

Installing the Switch

If your PC or terminal has a 25-pin serial connector, first attach a 9-pin to

25-pin straight-through adapter at one end of the console cable.

Figure 2-27. Connecting the Cable for a Direct Console Connection

3. Power on the management console (terminal or PC). If you are using a

PC, start the PC terminal program.

4. For a direct console connection through the Console port:

a. Press

[Enter] two or three times to display the copyright page and the

message “Press any key to continue”.

b. Press any key to display the switch console command (CLI) prompt;

for example: ProCurve Switch 6600-24G#

c. Continue the console session to configure the switch by following the

procedure in “Minimal Configuration Through the Out-of-Band

Console Connection” on page 3-2.

Important You must use the out-of-band console connection to minimally configure the

switch with an IP address and subnet mask before you can use an in-band or

out-of-band networked connection to manage the switch. Continue with

“Recommended Minimal Configuration” on page 3-1 for more information.

DB9-to-DB9 Console Cable

shipped with 6600-24G and

6600-24G-4XG Switches

Console Port

RJ45-to-DB9 Console Cable

shipped with 6600-24XG, 6600-

48G, and 6600-48G-4XG Switches

To a PC running a terminal

emulator program or a

VT-100 terminal

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

Keine Kommentare

HP HP ProCurve Series 6600 Spezifikationen Seite 54