HP HP ProCurve Series 6600 Spezifikationen PDF herunterladen (Seite 37)

2-13

Installing the Switch

Installation Procedures

Installing the Switch

3. Install the mounting brackets on the switch. (The mounting brackets are

shipped with the HP Procurve 6600 Switch: 4-Post Rack Mount Kit.)

If you install a 6600 Switch with the power side facing the cold aisle, you

must install the switch as shown in Option 1 or 2 to leave space for an air

plenum.

If you install a 6600 Switch with the port side facing the cold aisle, you

must install the switch as shown in Option 3 without an air plenum.

Depending on whether you install the switch in a power-side or port-side

mounting, locate the set of holes where you want to attach the mounting

brackets. Use eight M4 8mm screws (four per bracket) to attach both

brackets.

Note that in a power-side mounting, you must attach the brackets in

different positions according to the length of a 6600 Switch. The brackets

will extend beyond the back of the switch.

Figure 2-7. Attaching the Mounting Brackets on a 6600 Switch

4. Slide the switch onto the rails until the switch is fully inserted and the

mounting hole in each bracket lines up with the mounting holes in the

rack.

Figure 2-8. Installing a 6600 Switch in a 4-Post Rack

Mounting

screws

Bracket

Option 3 - Port-side mounting for all 6600

Switches

Option 1- Power-side mounting for 6600-24XG,

6600-48G, and 6600-48G-4XG Switches (24-inch

depth products)

Space for shorter

air plenum

Option 2 - Power-side mounting for

6600-24G and 6600-24G-4XG Switches

(20-inch depth products)

Space for longer

air plenum

Position the bracket in a power-side mounting according to the length of your 6600 Switch.

Power-side mounting for a 6600 Switch (Option 1 or 2) Port-side mounting for a 6600 Switch (Option 3)

Mounting Holes on Brackets

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 115 116

Keine Kommentare

HP HP ProCurve Series 6600 Spezifikationen Seite 37