HP 24S Betriebsanweisung PDF herunterladen (Seite 46)

TEstlink

To run a test of the link between the hub and another IEEE 802.3 device.

Note

The destination device must be able to send an IEEE 802.2 Test response

packet upon receipt of an IEEE 802.2 Test command packet.

You will be prompted for the 12-digit hexadecimal station address (also called MAC

address, Ethernet address, or physical address) of the destination device. You will then be

prompted for the number of test packets to send.

If any errors are reported during this test, there may be a fault on the link being tested or

on the destination device. For more information about testing network links, see chapter

4, “Troubleshooting”.

THinwatch <ON/OFF>

To enable

(

set to ON

)

or disable

(

set to OFF

)

Thinwatch on the ThinLAN port.

With Thinwatch enabled, the Fault and ThinLAN port LEDs will flash whenever the

ThinLAN port is auto-segmented.

(

If you don’t enable Thinwatch, the LEDs won’t flash.

)

Auto-segmentation occurs on the ThinLAN port when it is enabled but has no connector on

it, the connected segment is not properly terminated, or it experiences excessive collisions.

Segmentation of a twisted-pair port or the AUI port is always displayed on the

corresponding port LED and the Fault LEDs. See “Auto-Segmentation” in chapter 1.

The default setting is disabled to allow you to “bench test” the hub and not get a fault

indication. Enable Thinwatch if the ThinLAN port is being used; disable Thinwatch if it is

not being used.

Example: TH ON

(

This enables Thinwatch.

)

3-10 Operation

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 101 102

Keine Kommentare

HP 24S Betriebsanweisung Seite 46