HP 24S Betriebsanweisung PDF herunterladen (Seite 32)

No changes to the hub’s default configuration are required for the hub to operate correctly.

The hubs each have a console interface for customizing the hub’s configuration, monitoring

its activity, and running diagnostics.

To configure the hub, first connect a terminal or PC running a terminal emulator, as

described under “Console Connection” below. Then, use the console interface to change

the desired hub configuration parameters. The commands that you can use to change the

hub’s configuration are listed and described later in this section under “Configuration

Commands”.

(The HP 28688B Hub Plus and HP 28699A Hub Plus/48 can also be configured over the

network from an HP network management station. See the network management product

documentation for more information.)

Console Connection

Connect a terminal to the hub’s console port directly or through modems, as described

below.

Connecting a Terminal Directly

1. Connect a terminal, or a PC emulating a terminal, to the console port using an

RS-232-C cable. (For pin-outs and recommended cables see appendix A, “Cables

and Connectors”.)

2. Switch on the terminal’s power (or switch on the PC’s power and start the

terminal emulation program). Configure the terminal for 8 bits per character, 1

stop bit, no parity, Xon/Xoff handshaking, and a baud rate of 9600, 2400, 1200, or

300.

3. Press RETURN several times for the prompt, =>. The baud rate for

communication between the hub and the terminal is set automatically when you

press RETURN.

4. Customize the hub’s configuration (if needed)

2-14 Installation

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 101 102

Keine Kommentare

HP 24S Betriebsanweisung Seite 32