HP 24S Betriebsanweisung PDF herunterladen (Seite 44)

POrt <port> <ON/OFF>

To enable

(

set to ON

)

or disable

(

set to OFF

)

a hub port. The initial setting for all

ports is enabled (ON). To simplify network changes, unused ports need not be disabled.

You can use the Status command to check all the ports. The <port> parameter can be:

a twisted-pair port number – from 1 to 12 for the Hub/12 and Hub Plus and from

1 to 12 preceded by a group number for the Hub Plus/48 (for example B3 is port 3

in group B)

a twisted-pair port group number – A, B, C, or D (Hub Plus/48 only)

AUI or AU for the AUI port

THINLAN or TH for the ThinLAN port

ALL or AL (for all ports)

Example for the Hub/12 or Hub Plus: PO 1 OFF (This disables port 1.)

Example for the Hub Plus/48: PO A1 OFF (This disables port A1.)

REset

To run a hub self-test and reset the hub. This command also resets all the network

statistic counters, and the time since last reset to 0 (see the Counters command). The

current configuration is unchanged. The hub is not accessible from network management

software while it is being tested, but it continues to repeat data. If the hub is faulty, the

Fault LED will stay on. This command also terminates the console session (and

disconnects the phone line if using a modem) and resets the console port baud rate to be

automatically sensed. To restart the console session, reestablish the phone link (if used),

then press RETURN several times for the prompt.

SPeed <new speed>

To change the console port baud rate. Normally, the baud rate is automatically

sensed. Use this command to set the baud rate explicitly to 300, 1200, 2400, or 9600. You

will be prompted to set the terminal’s baud rate to the same speed and to press RETURN

several times for the prompt.

3-8 Operation

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 101 102

Keine Kommentare

HP 24S Betriebsanweisung Seite 44