
Hardware options installation 53
SAS-SATA hard drive cage option
NOTE: An optional SAS controller is required to support the SAS-SATA hard drive cage
installation.
1. Power down the server. ("Power down the server" on page 20)
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 21).
o Extend the server from the rack (on page 22).
3. Remove the access panel (on page 25).
4. For rack models, remove the bezel ("Remove the rack bezel" on page 23).
5. Remove the four screws from the hard drive cage blank.
6. Remove the cage blank.
7. Install the SAS controller into an empty slot ("Installing expansion boards" on page 63).
8. Connect the two SAS-SATA cables to the SAS controller.
Kommentare zu diesen Handbüchern