Hp Netserver E Server series Bedienungsanleitung PDF herunterladen (Seite 44)

Chapter 5 Installing Additional Boards

Installing Accessory Boards

Use this procedure to install accessory boards and observe the installation

guidelines listed earlier.

1. If the NetServer is already installed and working, power down the

NetServer.

Refer to Chapter 1, "Controls, Ports, and Indicators."

2. Disconnect the power cables and any external cables connected to the

NetServer.

If necessary, label each one to expedite re-assembly.

3. Remove the cover and turn the chassis feet inward.

Refer to Chapter 2, "Opening and Closing the HP NetServer."

This allows the NetServer to lie flat when turned on its side.

WARNING The power supply will continue to provide standby current to

the NetServer until the power cable is disconnected.

CAUTION Wear a wrist-strap and use a static-dissipating work surface

connected to the chassis when handling components. Ensure

the metal of the wrist-strap contacts your skin.

4. Lay the NetServer on its side (components showing).

5. Read the documentation included with the accessory board and follow any

special instructions.

NOTE Adding a PCI-to-PCI bridge board to the HP NetServer may

alter the NetServer’s boot order. This boot order can be

changed using the Setup Utility (press [F2] during the boot

process). Refer to "Boot Priority" earlier in this chapter.

6. Identify the accessory slot number to be used. See Figure 5-1.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 105 106

Keine Kommentare

Hp Netserver E Server series Bedienungsanleitung Seite 44