Hp NetRAID-4M Controller Bedienungsanleitung PDF herunterladen (Seite 76)

4-26

Command Line Interface User’s Guide

Displaying and Setting the Exception Report Interval

The interval timer attribute indicates the frequency of

S.M.A.R.T. exception reporting for specified disks.

The CLI allows you to do the following:

■ Display the S.M.A.R.T. interval timer setting for your disks

■ Set the S.M.A.R.T. interval timer

To display the interval timer setting for exception reporting, use the

disk show smart command, as in the following example. Note

that the Interval Timer column appears only if you specify the

/full switch with the disk show smart command. In the

following example, the Interval Timer (secs.) column shows the

exception reporting interval in seconds. In the example, the interval

is set to 0 for devices (2,1,0) and (2,2,0). The value of 0 indicates that

the interval is set according to the vendor. (Note that the example

eliminates some items in the disk show smart display to make

the example readable on this page.)

HPN0> disk show smart /full=TRUE

Executing: disk show smart /full=TRUE

Smart

Capable Log Interval Report Error

C:ID:L Device Errors Timer (secs.) Count Count

------ ------- ------ ------------- ------ -----

2:01:0 Y N 0 1 0

2:02:0 Y N 0 1 0

To set the S.M.A.R.T. exception reporting interval, use the disk

set smart command with the /interval_timer switch. You set

the interval in increments of 100 seconds. Specifying 0 seconds

instructs S.M.A.R.T. to use the vendor’s default interval. The

following example shows how to set the interval to 200 seconds on

SCSI device (2,1,0):

HPN0

disk set smart /interval_timer=200 (2,1,0)

Executing: disk set smart /interval_timer=50

(CHANNEL=2,ID=1,LUN=0)

SMART parameters on disk (2,01,0) were successfully set.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 335 336

Keine Kommentare

Hp NetRAID-4M Controller Bedienungsanleitung Seite 76