Hp Library and Tape Tools Bedienungsanleitung PDF herunterladen (Seite 81)

NOTE:

• Depending on the library model and test options selected, this test may overwrite data. The

test will not overwrite data on MSL, ESL, and EML series libraries. For more information, see

“Using the original version” (page 81).

• For instructions on how to perform this test, see “Using the Library Exerciser test”

(page 80).“Running tests and device-specific utilities” (page 29) or “Running the tests

(CSI)” (page 50).

• This test can take a long time on very large libraries. If a shorter test is desired, use the test

options to select a subset of elements to test.

Using the original version

The Library Exerciser test takes a test cartridge from a mail slot and performs random slot-to-slot

moves. The test then moves the test cartridge into every available drive and performs a short drive

test. This test is intended to exercise the robotics and robot drive hardware.

NOTE: Not all libraries are supported by the Library Exerciser test. If the test is not displayed in

the list of tests, then the selected device is not supported.

The following options are available for this test:

• Test Time Limit—Specify the time limit in minutes. Enter 0 for no time limit. The default

setting is 0.

• Move Command Timeout—Specify the maximum time allotted, in seconds, for each move

command before failure. The default is 600 seconds.

• Active Slot Range—Specify a range of slots to be tested. Enter a range of slot numbers

separated with a dash (for example: 2-5), or enter all to specify all slots. The default is all.

• Active Drive Range—Specify a range of drives to be tested. Enter a range of drives

separated with a dash (for example: 2-5), or enter all to specify all drives. The default is all.

• Drive Type Option—Specify the type of drives to be tested (in libraries that have mixed

drive types). Enter the type of drive (for example: LTO or DLT), or enter all to test all drive

types. The default is all.

• Check Inventory Mode—Specify whether to perform an active inventory check at beginning

of the test. The active inventory check can take a long time to perform. The default is on.

• Barcode Mode—Specify how bar codes are handled. Choose one of the following options:

Show all—Shows all bar codes.◦

◦ Show suspect—Shows only suspect bar codes (default).

◦ Off—Does not show bar codes.

• Slot-to-Slot Moves—Select one of the following options for the slot-to-slot test:

All—Moves all cartridges◦

◦ Random—Moves randomly selected cartridges (default)

◦ Off—No cartridges are moved

• Random Coverage—When Slot-to-Slot Moves is set to Random, specify the percentage of

units covered during random test. The default is 20%.

• Drive Load Mode—Specify whether or not to perform the Drive Load test. The default setting

is on.

Diagnostic tests 81

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 181 182

Keine Kommentare

Hp Library and Tape Tools Bedienungsanleitung Seite 81