The two options available for the Backup Performance test are as follows:
• Blocksize—Specify the blocksize (in bytes) to be read. Typical values are 32768
(32KB), 65536 (64KB). The default is 65536.
• Path—Specify the path to the directory to be read from.
Figure 42 Restore Performance test screen (CSI)
The following options are available for the Restore Performance Test:
• Filesize—Specify the size, in bytes, of the test files to be created.
• Number of Files—Specify the number of files to be created.
• Directory path—Specify the path of the directory where the test files will be written.
This must be a directory on the backup server being tested. Make sure that the path is
on the restore destination disk to measure the real data rate. Use a directory name that
you can find easily such as C:\Test so that you can easily delete the data later.
• Pattern—Specify one of the following data patterns:
◦ Fixed byte
◦ Incrementing byte
◦ Random data
◦ 1.6:1 compressible data
◦ 2:1 compressible data (suggested starting value)
◦ 3.1:1 compressible data
◦ 4.3:1 compressible data
4. Use the start command to start the test.
DDS Assessment test
DDS Assessment tests performed:
• Requires that cartridge be already loaded or in the process of loading when the test is started.
• Looks at the drive history (runs device analysis and looks for at DDS report information).
• Checks whether the drive is requesting cleaning.
104 Tests
Kommentare zu diesen Handbüchern