Hp ProCurve 520wl Wireless Access Point Bedienungsanleitung PDF herunterladen (Seite 72)

Advanced RADIUS Features

4-23

wireless port mapping

wireless port mappingwireless port mapping

wireless port mapping

When using Spanning Tree to configure WDS links, you must first configure the MAC address of the card to which the wireless

link will be established. Data transmitted on the WDS port goes directly, via point-to-point link, to the MAC address of the

wireless card you configure.

NOTE:

Since six (6) WDS ports can be configured for each card, you need to map paths from WDS ports to mutually

exclusive wireless port designations for Spanning Tree.

configuring the wl520 unit as a wireless repeater

configuring the wl520 unit as a wireless repeaterconfiguring the wl520 unit as a wireless repeater

configuring the wl520 unit as a wireless repeater

This configuration requires two or three WL520 devices. If you have three devices, a dedicated wireless WL520 unit should be

configured with Slot A and Slot B of the WL520 device wireless distribution link. This WL520 unit should not be connected to

a wired interface. Please note: A slot may repeat up to six wired links. Also, the other two wired WL520 units should be

configured so that one slot partners with the Wireless WDS partner.

If you have two devices, form a WDS link between them by configuring one wireless card in each WL520 as a dedicated

WDS port.

Additional Information: The WL520 unit should only allow client associations on those channels and network names that are

configured for a WDS link.

Result: The wireless WL520 unit functions as a repeater.

advanced radius features

advanced radius featuresadvanced radius features

advanced radius features

This section contains additional information about the WL520’s interaction with your network’s RADIUS servers.

fallback to primary radius server

fallback to primary radius serverfallback to primary radius server

fallback to primary radius server

This automatic feature ensures the primary RADIUS server is used to authenticate your network when it is available. If you have

configured the WL520 with a primary and a backup RADIUS server, the WL520 will switch to the backup server if the primary

server fails for any reason. After the unit has switched to the backup server, it will periodically check the status of the primary

RADIUS server every five (5) minutes. Once the primary RADIUS server is again online, the WL520 automatically reverts from

the backup RADIUS server back to the primary RADIUS server. All subsequent requests are sent to the primary RADIUS server.

radius start/stop accounting

radius start/stop accountingradius start/stop accounting

radius start/stop accounting

Using an external RADIUS server, the WL520 can track and record the length of client sessions on the access point by sending

RADIUS accounting messages per RFC2866. When a wireless client is successfully authenticated, RADIUS accounting is

initiated by sending an “Accounting Start” request to the RADIUS server. When the wireless client session ends, an

“Accounting Stop” request is sent to the RADIUS server.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 141 142

Keine Kommentare

Hp ProCurve 520wl Wireless Access Point Bedienungsanleitung Seite 72