Hp ProCurve 520wl Wireless Access Point Bedienungsanleitung PDF herunterladen (Seite 60)

Setting Filters

4-11

setting filters

setting filterssetting filters

setting filters

Setting protocol filters through the Ethernet Protocol Filter, TCP/UDP Port Filter, and the Advanced Filtering interface can impact

the performance of your network by limiting the amount of unnecessary traffic received from unsupported protocols. In

addition, various filters can be set up through the Static MAC Address Table to control the interaction between network devices

and to control the types of protocol packets distributed by your network.

This section describes the Ethernet Protocol, Advanced, and TCP/UDP Port filtering options. See Static MAC Address Filter for

information on the Static MAC address filter.

setting the ethernet protocol filter

setting the ethernet protocol filtersetting the ethernet protocol filter

setting the ethernet protocol filter

Use the Ethernet Protocol tab to set filters.

– Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the

Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the

Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the WL520 will

will will

will

not filter any of the Ethernet protocols listed in the Filter Table.

not filter any of the Ethernet protocols listed in the Filter Table. not filter any of the Ethernet protocols listed in the Filter Table.

not filter any of the Ethernet protocols listed in the Filter Table.

Filter Operation Type.

Filter Operation Type.Filter Operation Type.

Filter Operation Type. If set to Passthru

PassthruPassthru

Passthru, only the enabled

Ethernet Protocols listed in the Filter Table will pass through the bridge. If set to

Block

BlockBlock

Block, the bridge will block enabled

Ethernet Protocols listed in the Filter Table.

Figure 4-10

Figure 4-10Figure 4-10

Figure 4-10 Ethernet Filter Configuration Screen

Ethernet Filter Configuration Screen Ethernet Filter Configuration Screen

Ethernet Filter Configuration Screen

ethernet protocol filter table

ethernet protocol filter tableethernet protocol filter table

ethernet protocol filter table

This table is pre-populated with existing Ethernet Protocol Filters, however, you may enter additional filters by specifying the

appropriate parameters.

To add an entry, click

Add

AddAdd

Add, and then specify the Protocol Number

Protocol NumberProtocol Number

Protocol Number and a Protocol Name

Protocol NameProtocol Name

Protocol Name.

– Protocol Number

Protocol NumberProtocol Number

Protocol Number. Enter the protocol number. See http://www.iana.org/assignments/ethernet-numbers for a list of

protocol numbers.

–

Protocol Name

Protocol NameProtocol Name

Protocol Name. Enter related information, typically the protocol name.

To edit or delete an entry, click Edit

Edit Edit

Edit and change the information, or select Enable

EnableEnable

Enable,

, ,

, Disable

DisableDisable

Disable, or Delete

DeleteDelete

Delete from the Status pull-down

menu.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 141 142

Kommentare zu diesen Handbüchern

Keine Kommentare

Hp ProCurve 520wl Wireless Access Point Bedienungsanleitung Seite 60

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Router Hp ProCurve 520wl Wireless Access Point