HP Visualize b2000 - Workstation Spezifikationen PDF herunterladen (Seite 145)

Chapter 4 145

Changing Your Workstation’s Hardware Conﬁguration

Monitor Type

Troubleshooting Monitor Problems

In the event that your console stops displaying to your graphics device,

use the following procedure to set the console for displaying to an

external terminal.

Here are the steps to follow:

1. Power off the workstation.

2. Disconnect the workstation’s keyboard connector from the rear panel.

3. Connect a serial terminal emulator to the Serial 1 connector (the left

serial connector) on the rear panel.

4. Power on the workstation. The workstation will now display the

console to the terminal connected to Serial 1 port. Note that you can

use a 9-pin to 9-pin serial cable (HP F1044-80002) to connect an HP

OminiBook serial port to the workstation.

5. Set the monitor type and path using the Boot Console Interface. For

information see Chapter 5, “Displaying and Setting the Monitor

Type” on page 163.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 228 229

Keine Kommentare

HP Visualize b2000 - Workstation Spezifikationen Seite 145