HP Visualize b2000 - Workstation Spezifikationen PDF herunterladen (Seite 100)

100 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

Removable Media Devices

6. Tighten the two CD drive bracket screws as shown in Figure 4-21.

These should be tightened using 6 inch-pounds of torque.

Figure 4-21 Tightening the Bracket Screws

7. Place the audio, ATAPI and power cables inside the CD drive bay, and

position the cables so that they go under the bottom edge of the CD

drive bay’s rear cover. The CD drive bay’s rear cover’s edge is rounded

to keep you from cutting the cables. See Figure 4-22. Next, place the

end opposite the rear cover handle into the cover slot, rotate it into

place, and tighten the T-15 Torx/slotted screw using 6 inch-pounds of

torque. This will secure the rear cover in place. See Figure 4-22. You

have completed the removal of the CD drive.

Figure 4-22 Replacing the CD Drive Bay’s Rear Cover

Bracket

Screw

Bracket

Screw

Rear Cover

T-15

Torx/Slotted

Screw

Audio

Cable

Rear Cover

Handle

Power Cable

ATAPI Cable

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 228 229

Keine Kommentare

HP Visualize b2000 - Workstation Spezifikationen Seite 100