HP Visualize b2000 - Workstation Spezifikationen PDF herunterladen (Seite 141)

Chapter 4 141

Changing Your Workstation’s Hardware Conﬁguration

Monitor Type

Your workstation ships from the factory preset to use a monitor with a

speciﬁc resolution and frequency. If you replace your monitor with a

different type, you must reconﬁgure your workstation to support it.

There are three ways to conﬁgure your workstation to support a different

monitor type. They are discussed in the subsequent sections.

Setting the Monitor Type at Power On

If you replace your workstation’s monitor with a different type of

monitor, and you have not set the workstation’s graphics parameters by

using the Boot Console Interface’s monitor command, you can still

conﬁgure your workstation’s new monitor type when you reboot the

workstation.

To set the monitor type, you will need to:

1. Press the Tab key after your keyboard’s Num Lock light comes on

during the boot process to initiate the automatic monitor selection

process. Your system will query you for a new monitor type. Note that

if you have waited more than 2 minutes for a monitor type to appear,

go to the section “Troubleshooting Monitor Problems” in this chapter.

2. Select one of the monitor types listed on the screen and press Enter.If

your monitor is not listed in the section “Monitors” in Chapter 1,

“Overview,” a common monitor type to select is 12.

3. Answer yes, by pressing Y, to the system query to conﬁrm your

selection. Note that if you do not make a selection, the workstation

cycles through a limited number of monitor types continuously until

you do make your selection. See the section “Displaying and Setting

the Monitor Type” on page 163.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 228 229

Keine Kommentare

HP Visualize b2000 - Workstation Spezifikationen Seite 141