Chapter 4 121
Changing Your Workstation’s Hardware Configuration
Hard Disk Drives
4. Insert the T-15 Torx Hard Disk Mounting Screws through the rubber
mounting grommets and into the screw holes located on the sides of
the hard disk drive. See Figure 4-40.
Figure 4-40 Inserting the Hard Disk Drive
5. Slide the assembly into its hard drive slot, and push inward firmly
until the front of the hard disk drive bracket is flush with the disk
drive connector on the system board. See Figure 4-41. The bracket
hooks will lock into the chassis rail. The side panel should now be
replaced as described in the section “Closing the Side Panel” in this
chapter.
Hard Disk
Drive Bracket
Mounting
Grommets
(do not remove)
Hard Disk
Drive
T-15 Torx Shoulder Screw
Bracket Hooks
(quantity 4)
Kommentare zu diesen Handbüchern