HP LaserJet 4300 Series Betriebsanweisung PDF herunterladen (Seite 65)

ENWW Printing special paper 63

Setting custom paper sizes

When custom paper is loaded, size settings need to be selected in the program (the preferred

method), in the printer driver, or at the printer control panel. To reduce curl and other problems,

heavy paper and very small custom-size paper should be printed from tray 1 to the rear output

bin. (See “Printing to the rear output bin” on page 37.)

If the settings are not available in your program, set the custom paper size at the printer control

panel.

To set custom paper sizes

1 If you loaded a 500-sheet tray with custom paper, be sure that the knob is set to Custom.

(See “Loading tray 2 or an optional 500-sheet tray” on page 43.)

2 Press S

ELECT ( ) to open the menus.

3 Use U

P ARROW () or DOWN ARROW ( ) to scroll to PAPER HANDLING, and then press

ELECT ().

4 Use U

P ARROW () or DOWN ARROW ( ) to scroll to TRAY 1 SIZE or TRAY [N] SIZE (where

[N] is the number of the tray), and then press S

ELECT ().

5 Use U

P ARROW () or DOWN ARROW ( ) to scroll to CUSTOM, and then press SELECT ().

6 Use U

P ARROW () or DOWN ARROW ( ) to scroll to INCHES or MM (millimeters), and then

press S

ELECT ( ). This selects the measurement units for determining the size of your

custom paper.

7 Use U

P ARROW ( ), then DOWN ARROW ( ), and then press SELECT ( ) to set the

X dimension (the front edge of the paper, as shown in the figure above). The X dimension

can be 76 to 216 mm (3 to 8.5 inches).

8 Use U

P ARROW ( ), then DOWN ARROW ( ), and then press SELECT ( ) to set the

Y dimension (the side edge of the paper, as shown in the figure above). The Y dimension

can be 127 to 356 mm (5 to 14 inches). For example, if the custom paper is 203 by 254 mm,

set X=203 mm and Y=254 mm.

X (front edge)

Y (side edge)

Feed short

edge first

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 217 218

Keine Kommentare

HP LaserJet 4300 Series Betriebsanweisung Seite 65