5. Pull out on the top of the assembly while pressing in on two tabs (2). Once the top is
released, pull up slightly and outward to remove the developing contact assembly (3). As
you remove the assembly, unroute the grounding wire (4).
Reinstallation tip
When installing the developing contact assembly, install the tab at the bottom of the
assembly into the slot in the frame, then insert and latch the two tabs (2) at the top.
Figure 6-135.
Developing contact assembly removal (3 of 3)
290 Chapter 6 Removal and replacement ENWW
Kommentare zu diesen Handbüchern