HP Remote Graphics Software (RGS) Bedienungsanleitung PDF herunterladen (Seite 54)

domain1 "joe user" RC_4 RC_5 RC_6

Starting RGS Receiver in Directory Mode

To start RGS Receiver in Directory Mode on Windows:

NOTE: Before attempting a connection in Directory Mode for the rst time, HP recommends that you rst

verify that RGS can connect to each computer individually.

▲

Windows 7: Select Start, select All Programs, select HP, select HP Remote Graphics Software, and then

select HP RGS Receiver Directory Mode.

Windows 8.1: Select the HP RGS Receiver Directory Mode tile on the Start screen.

Windows 10: Select Start , type RGS, and then select HP RGS Receiver Directory Mode from the search

results.

Alternately, RGS Receiver can be started in Directory Mode on the command line, using either of the following:

rgreceiver.exe -directory FileName

rgreceiver.exe -directory

If a le name is specied after -directory, RGS Receiver will use that le as the directory le. If no le name is

specied, the user is prompted by RGS to specify the path and name of the directory le.

In Directory Mode, RGS Receiver displays the name of the directory le. The Change button enables you to

specify a dierent directory le. The Connect All button is used to establish a connection to the senders listed

in the directory le.

After clicking Connect All, you’ll need to independently authenticate and log into each sender.

To bring a specic remote display window to the front:

1. Enable Setup Mode using the hotkey sequence (see Setup Mode (non-touch GUI only) on page 15).

2. Press Tab to open the remote display window selector, and then select the desired remote display

window.

44 Chapter 6 Using RGS features

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 96 97

Keine Kommentare

HP Remote Graphics Software (RGS) Bedienungsanleitung Seite 54