HP JetAdvantage Security Manager 10 Device E-LTU Bedienungsanleitung PDF herunterladen (Seite 8)



All solutions

Control Panel timeout = 60s (this is the device default. Policy was 20s)



HPAC

Legacy Firmware Upgrades

= enabled (for install and run)

Allow PJL Access

= enabled (for run)

Remote Firmware Upgrade (RFU)

= enabled (for run)



SafeCom

Legacy Firmware Upgrades

= enabled (for install and run)



v310 and earlier only (v312 uses SHA-256)



Equitrac

No changes to policy needed



HPCR

SNMP v1/v2 write = enabled (for install and run)

Therefore, for a solution such as HP Access Control, the important settings and their values to ensure

the solution installs and runs properly are the following:

● EWS password required for installation and configuration

● Remote Firmware Upgrade enabled

● File Access and PJL Disk Access enabled

● PJL password not set

● Information Tab Requires Administration Password for Access disabled.

● PJL Access Commands enabled.

● 9100 Printing, WS-Discovery, OXPd Services, and Web Services print must be enabled.

● Legacy Firmware Upgrade enabled

CREATING A POLICY

The Security Manager Policy Editor allows print administrators with minimal security knowledge, as

well as experienced security administrators, to build a valid, comprehensive security policy to deploy

across the HP imaging and printing fleet. The Policy Editor provides security setting intelligence

through basic definition, recommendations, validations and constraints to ensure creation of a valid

policy.

A new policy is created on the Policies tab by selecting New Policy in the menu bar that slides open

from the left hand side of the screen.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 115 116

Keine Kommentare

HP JetAdvantage Security Manager 10 Device E-LTU Bedienungsanleitung Seite 8