Hp A3312A Bedienungsanleitung PDF herunterladen (Seite 19)

Installation & Configuration

Installing Additional Modules

Installation

Installing a Disk Module

CAUTION! The disk modules located in slots A1, A2, B1, and B2 will power-on first, so a

boot device should only be installed in one of those slots.

NOTE! Replacement of a disk module is not the same as installing additional capacity in an

operating storage system! To add capacity, follow the steps below. To replace a disk module,

see Chapter 4.

To install a disk module:

1. Shut down the host and power-off the storage system.

2. Read and remove the module “Attention” label (see Figure 7).

Figure 7. Removing the Attention Label

3. Pull out the module lever (see Figure 8).

CAUTION! Pull the module lever all the way out, or the module will jam in the slot.

4. Install the disk module into the storage system.

5. Push in the module lever until it clicks to lock the module in place.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 148 149

Keine Kommentare

Hp A3312A Bedienungsanleitung Seite 19