Hp MPX200 Multifunction Router Bedienungsanleitung PDF herunterladen (Seite 31)

Syntax

list vlan

Example

c:\> rcli list vlan /ip=10.0.0.12

[10.0.0.12]

-port=1 -ipv4 -enable=yes -id=32 -priority=2

-port=2 -ipv4 -enable=no

-port=3 -ipv4 -enable=no

-port=4 -ipv4 -enable=no

-port=1 -ipv6 -enable=no

-port=2 -ipv6 -enable=no

-port=3 -ipv6 -enable=no

-port=4 -ipv6 -enable=no

list vp_group

The list vp_group command lists the names of all VP groups known to the router.

NOTE: This command is not supported for MPX100 routers.

TIP: To view details for a single VP group, use the show vp_group command.

Syntax

list vp_group

Example

c:\> rcli list vp_group /ip=10.0.0.12

[10.0.0.12]

VpGroup count = 4

-vpgindex=1 "VPGROUP_1" (enabled)

-vpgindex=2 "VPGROUP_2" (enabled)

-vpgindex=3 "VPGROUP_3" (enabled)

-vpgindex=4 "VPGROUP_4" (enabled)

The login iscsi_target command

Syntax

NOTE: This command requires router firmware version 3.2.3.0 or later.

Keywords

Specifies the port number for the outbound iSCSI port.-port

Specifies that CHAP is enabled for this initiator. If this keyword is not used, the default

is disabled. Values are:

-chap_enable=

• yes

• no

• on

• off

list vp_group 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 119 120

Keine Kommentare

Hp MPX200 Multifunction Router Bedienungsanleitung Seite 31