HP StorageWorks 9030 Virtual Library System Bedienungsanleitung PDF herunterladen (Seite 35)

Table 5 Cabling Ethernet Switch #2 (SW2) (continued)

Connects toDescriptionItem

Ethernet port of FC switch #2 (FC SW2) via Ethernet cablePort 2323

Port 24 of Ethernet switch #1 (SW1) via Ethernet cablePort 2424

Table 6 Cabling Ethernet Switch #3, if present (SW1 of a second kit)

Connects toDescriptionItem

Ethernet port of RAID Controller 2 of additional base array enclosures via

Ethernet cable

Ports 17–2017–20

Table 7 Cabling Ethernet Switch #4, if present (SW2 of a second kit)

Connects toDescriptionItem

Ethernet port of RAID Controller 1 of additional base array enclosures via

Ethernet cable

Ports 17–2017–20

NOTE: Ethernet switch #1 is on the bottom and switch #2 is on the top. If present, Ethernet switch

#3 is on the bottom and switch #4 is on the top.

1. Connect the Ethernet switches to each other and to the Fibre Channel switches using

Table 4 (page 34) and Table 5 (page 34).

2. Connect the Ethernet switches to the nodes and base array enclosures if not already connected.

If installing multiple arrays:

a. Connect an Ethernet cable from Ethernet switch #1 to RAID controller 2 of additional

arrays in order (array 1, array 2, etc.). Use the switch #1 ports in this order: 20, 17, 18,

15, 16, 13, 14.

b. Connect an Ethernet cable from Ethernet switch #2 to RAID controller 1 of additional

arrays in order (array 1, array 2, etc.). Use the switch #2 ports in this order: 20, 17, 18,

15, 16, 13, 14.

NOTE: Each rack supports up to four arrays.

3. If installing a second connectivity kit in rack 4:

a. Connect an Ethernet cable from Ethernet switch #3 to RAID controller 2 of additional

arrays in order (array 13, array 14, etc.). Use the switch #3 ports in this order: 19, 20,

17, 18.

b. Connect an Ethernet cable from Ethernet switch #4 to RAID controller 1 of additional

arrays in order (array 13, array 14, etc.). Use the switch #4 ports in this order: 19, 20,

17, 18.

WARNING! Do not connect cables to unused ports on Ethernet switch #1 or #2. Doing so could

result in data loss.

NOTE: Do not secure the Ethernet cables at this time. You will secure them with the Fibre Channel

cables.

Installing the Ethernet Switch 2510–24 into a Rack

VLS9200 Entry-level systems use the Ethernet Switch 2510–24. No other switches are required.

NOTE: There are no rails associated with this switch.

Installing the Ethernet Switch 2510–24 into a Rack 35

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 267 268

Keine Kommentare

HP StorageWorks 9030 Virtual Library System Bedienungsanleitung Seite 35