HP PROCURVE 6120 Bedienungsanleitung PDF herunterladen (Seite 267)

100

101

11-15

Port Trunking

CLI: Viewing and Configuring Port Trunk Groups

Configuring a Static Trunk or Static LACP Trunk Group.

This example uses ports C4 - C6 to create a non-protocol static trunk group

with the group name of Trk2.

ProCurve(config)# trunk c4-c6 trk2 trunk

Removing Ports from a Static Trunk Group. This command removes

one or more ports from an existing Trkx trunk group.

Caution Removing a port from a trunk can create a loop and cause a broadcast storm.

When you remove a port from a trunk where spanning tree is not in use,

ProCurve recommends that you first disable the port or disconnect the link

on that port.

For example, to remove ports C4 and C5 from an existing trunk group.

ProCurve(config)# no trunk c4-c5

Enabling a Dynamic LACP Trunk Group. In the default port configura-

tion, all ports on the switch are set to disabled. To enable the switch to

automatically form a trunk group that is dynamic on both ends of the link, the

ports on one end of a set of links must be LACP Active. The ports on the other

end can be either LACP Active or LACP Passive. The active command enables

the switch to automatically establish a (dynamic) LACP trunk group when the

device on the other end of the link is configured for LACP Passive.

Syntax:

trunk < port-list > < trk1 ... trk60 > < trunk | lacp >

Configures the specified static trunk type.

Syntax:

no trunk < port-list >

Removes the specified ports from an existing trunk group.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 588 589

Kommentare zu diesen Handbüchern

Keine Kommentare

HP PROCURVE 6120 Bedienungsanleitung Seite 267

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP PROCURVE 6120