HP NonStop G-Series Betriebsanweisung PDF herunterladen (Seite 53)

Object Server Commands

SQL/MX Connectivity Service Administrative Command Reference—526350-005

4-5

STOP SERVER

This command puts the server in the stopping state. The actual termination occurs at

different times, depending on the stop-mode attribute you specify.

Check on progress by using the INFO SERVER command.

Command syntax is:

obj-name

[[[\system-name.]$service-name.]$server-name]

system-name

is the name of the current system of up to 16 CPUs with the same Expand

address and where the target MXCS process is running. system-name and

service-name identify one service instance.

service-name

is the name of the MXCS association server process that owns this server.

server-name

is the name of the MXCS server process to be stopped. It must not be an

association or configuration server. It cannot be the asterisk (*) wild card.

AFTER stop_mode

specifies the termination time of the MXCS server with a key value:

NOW

terminates the server abruptly (abort as fast as possible). A client connected to

the server receives the communication link failure error on the next

action that accesses the server. The client is required to either disconnect and

connect to another server or to quit. Incomplete transactions are rolled back.

This is the default mode.

Considerations—STOP SERVER



STOP SERVER is a sensitive command.



STOP SERVER deletes the server from the system. The server does not transition

to a stopped state and wait for a start command after STOP SERVER.



The asterisk (*) wild card is not supported.



The service that starts the MXCS server owns it and stops it.

STOP SERVER [obj-name] [,AFTER stop-mode];

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 102 103

Keine Kommentare

HP NonStop G-Series Betriebsanweisung Seite 53