HP Moonshot-180G Betriebsanweisung PDF herunterladen (Seite 12)

100

101

Using the Command-Line Interface

CLI Command Reference

September 2014 Page 12

HP Moonshot Switch Module CLI Command Reference

Section 2: Using the Command-Line Interface

The command-line interface (CLI) is a text-based way to manage and monitor the system. You can access the

CLI by using a direct serial connection or by using a remote logical connection with Telnet or SSH.

This chapter describes the CLI syntax, conventions, and modes. It contains the following sections:

• “Command Syntax” on page 12

• “Command Conventions” on page 13

• “Common Parameter Values” on page 14

• “unit/slot/port Naming Convention” on page 15

• “Using the “No” Form of a Command” on page 13

• “Command Modes” on page 17

• “Command Completion and Abbreviation” on page 20

• “CLI Error Messages” on page 20

• “CLI Line-Editing Conventions” on page 21

• “Using CLI Help” on page 22

• “Accessing the CLI” on page 23

Command Syntax

A command is one or more words that might be followed by one or more parameters. Parameters can be

required or optional values.

Some commands, such as

show network or clear vlan, do not require parameters. Other commands, such as

network parms, require that you supply a value after the command. You must type the parameter values in a

specific order, and optional parameters follow required parameters. The following example describes the

network parms command syntax:

network parms ipaddr netmask [gateway]

• network parms is the command name.

•

ipaddr and netmask are parameters and represent required values that you must enter after you type the

command keywords.

•

[gateway] is an optional parameter, so you are not required to enter a value in place of the parameter.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 718 719

Kommentare zu diesen Handbüchern

Keine Kommentare

HP Moonshot-180G Betriebsanweisung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP Moonshot-180G