HP Integrity NonStop H-Series Betriebsanweisung PDF herunterladen (Seite 83)

HP NonStop Shadowbase Command Definitions

Collector Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

indicate which processor is used. The CPULIST can be altered.

However, it can’t be altered to disabled (-1).

DEBUG { OFF }

{ ONSTART }

{ ONERROR }

Initial Changed

Version Version Values Default Value Specifications Alter

2.000 OFF ONSTART ONERROR No

Specifies whether a Collector enters debug mode and under what

condition. This should only be set when HP Shadowbase instructs you to

do so for diagnosing problems.

OFF the Collector does not enter debug mode.

ONSTART the Collector enters debug mode on start-up.

ONERROR the Collector enters debug mode on an error event.

If this parameter is omitted, the default is OFF.

EXPANDRECOVERY { OFF }

{ ON }

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.700 OFF OFF ON No

This specifies whether a Collector tries to reconnect to the Consumer

automatically if there is a failure in the Expand connection between two

nodes. The default is OFF. This parameter cannot be set to ON if the

RESOLVELOCKSQ parameter is set to ON.

EXTENDEDSTATS { OFF }

{ ALL }

{EXCLUDE}

{INCLUDE}

Initial Changed

Version Version Values Default Minimum Maximum Alter

4.070 ALL OFF ALL Yes

This parameter specifies whether a COLL will collect extended statistics

and, if so, what will be reported for the STATS AUD command. When set

to OFF, extended statistics will not be accumulated. When set to ALL,

extended statistics will be gathered and both excluded and included

file/table partition statistics will be reported. When set to EXCLUDE, only

excluded file/table partition statistics will be reported. When set to

INCLUDE, only included file/table partition statistics will be reported.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 345 346

Keine Kommentare

HP Integrity NonStop H-Series Betriebsanweisung Seite 83