HP Integrity NonStop H-Series Betriebsanweisung PDF herunterladen (Seite 117)

HP NonStop Shadowbase Command Definitions

Consumer Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

108

audmon_name

Optionally specifies the Guardian process name for the HP Shadowbase

monitor process controlling the replication environment. If omitted, the

currently opened replication environment will be used.

cons_name

Is the logical name of a previously defined Consumer.

cons_parameter

Is an attribute to change. It consists of a keyword and a value or set of

values for that parameter. Available parameters can be found in the SET

CONS section.

If you receive an error during execution of an alter command, do an INFO

CONS to check the values.

See the SET CONS command description for more information on the

cons_parameters.

CLEARTX CONS Command

The CLEARTX CONS command will cause a CONS to remove a

transaction from its internal transaction tracking list and can be used

regardless of a transaction’s status in TMF.

USE THIS COMMAND VERY CAUTIOUSLY, ONLY AFTER

CONSULTATION WITH HP SHADOWBASE SUPPORT, AS IT COULD

LEAVE ACTIVE TRANSACTIONS IN TMF FOR A CONS (AND THESE

ACTIVE TRANSACTIONS MAY EVENTUALLY BE AUTOMATICALLY

ABORTED BY TMF ON THE TARGET SYSTEM, REGARDLESS OF

THE EVENTUAL END STATE OF THE ORIGINAL TRANSACTION ON

THE SOURCE SYSTEM). USE OF THIS COMMAND MAY RESULT IN

TARGET DATABASE INCONSISTENCIES WITH THE SOURCE

DATABASE.

The TRANSID entered is the original audit trail transaction identifier that

was captured by the COLL, not the CONS’s replication transaction

identifier for the TMF transaction it starts.

The syntax for CLEARTX is as follows. The <consname> is the name of

the CONS object that is tracking the transaction. The TRANSID can be

entered in external or internal form and must be a transaction that is active

in the CONS’s internal tracking list. Use DUMPTX to see the transaction

list or INFOTX to see the detailed information for this specific transaction.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 345 346

Keine Kommentare

HP Integrity NonStop H-Series Betriebsanweisung Seite 117