HP Integrity NonStop H-Series Betriebsanweisung PDF herunterladen (Seite 40)

HP NonStop Shadowbase Command Definitions

Monitor Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

2.700 OFF OFF ON Yes

Enables or disables AUDMON from automatically restarting Collectors and

Consumers in the event a process fails. Restart behavior is affected by

the BACKUPCPU, FAILMAX, FAILRETRYDELAY, and FAILSPAN

Collector parameters and by the BACKUPCPU Consumer parameter.

The default is OFF.

AUTOSTOP { ON }

{ OFF }

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.800 OFF OFF ON Yes

Enables or disables AUDMON from automatically stopping Collectors and

the associated Consumers in the event communication with a Collector

process is lost. This will not automatically stop a Collector if audit reading

is falling behind or if a Collector has abended. The default is OFF.

AUDMON will check the COLL status according to the AUD

MONITORRATE <seconds> parameter. See SET COLL ADTAUTOSTOP

for setting for the shutdown conditions.

BACKUPCPU num

Initial Changed

Version Version Values Default Value Specifications Alter

2.700 None Valid CPU number Yes

This specifies the number of the CPU to be used when AUDMON is to run

as a HP NonStop process-pair. It should be a different value than that

entered when the AUDMON process was started from TACL. It must be

an existing CPU number.

This value defaults to <nothing>, meaning that the AUDMON will not run

as a process pair (which means that the AUDMON will not survive a

failure of the primary CPU). Supplying any other valid CPU number

means that the AUDMON will run as a process pair, with the backup

process located in the supplied CPU (which means that the AUDMON will

survive a failure of the primary CPU).

CONFIRMCONTROL { ON }

{ OFF }

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.000 OFF OFF ON Yes

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 345 346

Keine Kommentare

HP Integrity NonStop H-Series Betriebsanweisung Seite 40