HP EN Series Betriebsanweisung PDF herunterladen (Seite 128)

hp officejet 4200 series

chapter 12

118

fax setup

faxing from a DSL line

If you have a digital subscriber line (DSL) service through your phone company,

use the instructions in this section to connect a DSL filter between the telephone

wall jack and your HP Officejet. This filter removes the digital signal that would

block your HP Officejet from communicating properly with the telephone line.

Caution! If you have a DSL line and you do not connect the DSL

filter, you will not be able to send and receive faxes with your

HP Officejet.

Caution! If you do not use the supplied cord to connect from the

DSL filter to your HP Officejet, you may not be able to fax

successfully. If you live in one of the countries listed in the table on

page 119, you received a special 2-wire cord. This special 2-wire

cord is different from the more common 4-wire phone cords you

might already have in your office. For more information about how

to tell the difference between the cords, see I have difficulties when

sending faxes and when receiving faxes on page 146.

1 Obtain a DSL filter from your DSL provider.

2 Using the phone cord supplied in the box with your HP Officejet, connect

one end to the open port on the DSL filter, then connect the other end to the

port labeled “1-LINE” on the back of your HP Officejet.

3 Connect the DSL filter cord to the telephone wall jack.

4 Proceed to how to tell if the following instructions apply to you on

page 119 to determine what else you need to do to finish setting up your

HP Officejet.

Telephone

wall jack

Back view of the HP Officejet

Use t

e p

one cor

supp

the box with your HP Officejet

DSL filter

supplied by your

DSL provider

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 165 166

Keine Kommentare

HP EN Series Betriebsanweisung Seite 128