HP X Unified Security Platform Series Betriebsanweisung PDF herunterladen (Seite 67)

configure

X Family CLI Reference V 2.5.1 59

duration minutes

interval at which the X family

device will check with the time server.

enable

turns on NTP timekeeping.

fast < enable | disable >

enables the device to trust the NTP server after the first time query. This sets the local time on

the device immediately, but there is a risk that the set time will be incorrect.

offset seconds

If the difference between the new time and the current time is equal to or greater than the

offset, the new time is accepted by the device. A zero value will force time to change every

time the device checks.

peer server1[:port1] [server2[:port2] [server3[:port3] [server4[:port4] ] ] ]

sets the IP address of the network peer. The port number default is the IANA NTP port

number (123).

server server1[:port1] [server2[:port2] [server3[:port3] [server4[:port4] ] ] ]

sets the IP address of the NTP server. The port number default is the IANA NTP port number

(123).

Using conf t ntp

turn NTP

timekeeping

Use conf t ntp to enable NTP timekeeping.

hostname# conf t ntp enable

turn off NTP

timekeeping

Use the conf t ntp disable to turn off NTP timekeeping and use the device CMOS clock instead.

hostname# conf t ntp disable

conf t port protocol [add port-number | delete port-number]

The configure terminal port command configures additional ports associated with specific

applications, services, and protocols to expand scanning of traffic.

conf t profile profile-name

The configure terminal profile command enables you to create, modify, and delete security or traffic

management profiles.

Note: The following protocols are allowed: auth, dnstcp, dnsudp, finger, ftp, http,

imap, ircu, mssql, nntp, pop2, pop3, portmappertcp, portmapperudp, rlogin, rsh,

smb, smtp, snmptcp, snmpudp, ssh, and telnet.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 141 142

Keine Kommentare

HP X Unified Security Platform Series Betriebsanweisung Seite 67