HP 100VG Betriebsanweisung PDF herunterladen (Seite 28)

4. Complete the Hub Network Connections

Reconnect the hub to the power source and then make the network

connections to the hub.

Making network connections consists of the following procedures:

connecting to network end nodes, such as personal computers

connecting to another 100VG hub (“cascading”)

connecting to a Ethernet/IEEE 802.3 (10 Mbit/s) network (optional)

managing your cables

Connecting End Nodes

End node connections on the Hub-14 consists of ports numbered 1 through

12B. For the RJ-45 ports, the cable used to connect to each LAN port must

contain four twisted-pairs (8 wires total) and must be wired “straight

through”. Refer to appendix A for wiring diagrams.

To connect to a LAN port, push the RJ-45 plug on the cable into the RJ-45

jack until the tab on the plug clicks into place.

To disconnect an RJ-45 plug, press the small tab on the plug and pull the

plug out of the RJ-45 jack.

Note If you have purchased an optional transceiver and installed it into port 12B

to be used as a downlink port, downlink port 12A is not available for a cable

connection; cables connected to this port will not transfer any data.

RJ-45 plug

unshielded twisted-pair cable

Installing the

HP AdvanceStack Hub

Installing the HP AdvanceStack Hub

1-14

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 115 116

Keine Kommentare

HP 100VG Betriebsanweisung Seite 28