HP Firewall Series Installationshandbuch PDF herunterladen (Seite 25)

Figure 21 HyperTerminal window

Step5 Click Properties in the HyperTerminal window to enter the aaa Properties dialog box. Click the Settings

tab, set the Emulation to VT100, and then click OK.

Powering on the firewall

Checking before power-on

Before powering on the firewall, verify the following items:

• The power cord and grounding cable are properly connected.

• The power source matches that required by the firewall.

• The console cable is properly connected; the terminal or PC used for configuration has started; and

the configuration parameters have been set.

Checking after power-on

After powering on the firewall, check the following items:

• The LEDs on the front panel are normal. For information about the LED status, see the chapter

“Appendix B LEDs.”

• The fans work properly, and you can hear fan rotating.

• The configuration terminal displays information normally. You can see the startup window on the

local configuration terminal.

• After the POST, the system prompts you to press Enter. When the command line prompt appears,

the firewall is ready to configure.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Keine Kommentare

HP Firewall Series Installationshandbuch Seite 25