Hp ProLiant ML310 G4 Server Bedienungsanleitung PDF herunterladen (Seite 32)

Hardware options installation 32

Install the retaining screw.

IMPORTANT: When installing a SCSI tape drive, an optional SCSI HBA controller is required.

8. Connect the data and power cables to the back of the tape drive.

9. Connect the data cable to the SCSI controller.

10. Remove the applicable bezel blanks from the bezel.

11. Install the bezel ("Unlock the tower bezel" on page 17).

12. Install the access panel (on page 17).

13. Power up the server (on page 16).

Diskette drives

A diskette drive can be installed in the server in the following ways:

• Install a diskette drive in the chassis ("Installing a legacy diskette drive" on page 32)

• Install a diskette drive using a USB cable (when using operating systems that support USB)

("Installing a USB diskette drive" on page 33)

When using operating systems that support USB, the server supports USB devices, including, but not

limited to:

• CD-ROM drives

• Diskette drives

• Keyboard

• Mouse

For other operating systems, the ROM provides USB support for a keyboard, mouse, and diskette drives,

which do not support USB, but not for CD-ROM drives.

ROM legacy USB support is available during POST and while the operating system is running. The

maximum device support is two USB keyboards, two USB mouse devices, and one layer of hubs.

Installing a legacy diskette drive

1. Power down the server (on page 16).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Keine Kommentare

Hp ProLiant ML310 G4 Server Bedienungsanleitung Seite 32