Hp ProLiant ML310 G4 Server Bedienungsanleitung Seite 24
- Seite / 88
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Setup 24
Item Description
6 USB connectors (2)
7 RJ-45 Ethernet connector
8 RJ-45 connector (iLO 2)
9 Parallel connector
2. Connect the power cord to the rear of the server.
3. Connect the power cord to the AC power source.
WARNING: To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important
safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed
against it. Pay particular attention to the plug, electrical outlet, and the point where
the cord extends from the server.
Installing the operating system
To operate properly, the server must have a supported operating system. For the latest information on
supported operating systems, refer to the HP website (http://www.hp.com/go/supportos
).
Two methods are available to install an operating system on the server:
• SmartStart assisted installation—Insert the SmartStart CD into the CD-ROM drive and reboot the
server.
• Manual installation—Insert the operating system CD into the CD-ROM drive and reboot the server.
This process may require you to obtain additional drivers from the HP website
(http://www.hp.com/support
).
Follow the on-screen instructions to begin the installation process.
For information on using these installation paths, refer to the SmartStart installation poster in the HP
ProLiant Essentials Foundation Pack, included with the server.
NOTE: For software SATA RAID configuration, a driver diskette must be created and is only supported with
manual OS installation.
When installing third-party drivers, see the following additional information:
• To install an OS with the Software SATA RAID, see "Installing an operating system (Software
SATA RAID) (on page 42)."
Registering the server
To register the server, refer to the HP Registration website (http://register.hp.com).
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Component identification 6
- Front panel LEDs and buttons 7
- Rear panel components 8
- Rear panel LEDs 9
- System board components 10
- System maintenance switch 11
- System board LEDs 12
- SAS and SATA device numbers 14
- Fan locations 15
- Operations 16
- Install the access panel 17
- Unlock the tower bezel 17
- Remove the access panel 17
- Operations 18 18
- In this section 19
- Rack planning resources 20
- Optimum environment 20
- Temperature requirements 21
- Power requirements 21
- Warnings and cautions 22
- Installing hardware options 23
- Setting up a server 23
- Registering the server 24
- Introduction 25
- Hard drives 26
- SAS controller 28
- DVD-ROM drive 29
- USB tape drive 30
- Full-height tape drive 30
- Diskette drives 32
- Expansion boards 34
- Cabling 36
- SAS cabling 37
- Configuration and utilities 38
- HP ROM-Based Setup Utility 39
- BIOS Serial Console 40
- Array Configuration Utility 40
- Software SATA RAID 41
- Management tools 44
- Erase Utility 45
- Management Agents 45
- HP Systems Insight Manager 45
- USB support 45
- Diagnostic tools 46
- Keeping the system current 47
- Resource Paqs 48
- ProLiant Support Packs 48
- Care Pack 48
- Battery replacement 49
- Troubleshooting 50
- Symbols on equipment 51
- Symptom information 52
- Loose connections 53
- Service notifications 53
- Troubleshooting flowcharts 54
- General diagnosis flowchart 55
- Symptoms: 57
- Troubleshooting 59 59
- POST problems flowchart 60
- OS boot problems flowchart 61
- Troubleshooting 63 63
- Possible causes: 64
- Redundancy failure 64
- Troubleshooting 65 65
- FCC rating label 66
- FCC logo, United States only 67
- Modifications 68
- Japanese notice 69
- BSMI notice 69
- Korean notice 70
- Laser compliance 70
- Battery replacement notice 70
- Electrostatic discharge 72
- Specifications 73
- Technical support 75
- Technical support 76 76
- Customer Self Repair 77
- Reparo feito pelo cliente 79
- Technical support 80 80
- Technical support 81 81
- Technical support 82 82
- Acronyms and abbreviations 83
- Index 86 86
- Index 87 87
- Index 88 88
Verwandte Produkte und Handbücher für Computerhardware Hp ProLiant ML310 G4 Server
(142 Seiten)
(82 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.071 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern