Hp NetRAID 1 Controller Bedienungsanleitung PDF herunterladen (Seite 69)

Connector Pinouts

High-Density 68-Pin SCSI Connector and P-Cable Single-

Ended Cable Pinout

High-Density Connector

The following facts apply to the information in the High-Density SCSI connector table below:

• A hyphen before a signal name indicates that signal is active low.

• The connector pin refers to the conductor position when using 0.025 inch centerline flat

ribbon cable with a high-density connector (AMPLIMITE .050 Series connectors).

• Eight-bit devices connected to the P-Cable must leave the following signals open: -dB (8),

-dB (9), -dB (10), -dB (11), -dB(12), -dB (13), -dB (14), -dB 15), and -dB (P1).

CAUTION Lines labeled RESERVED should be connected to GROUND in the bus

terminator assemblies or in the end devices on the SCSI cable.

RESERVED lines should be open in the other SCSI devices, but can be

connected to GROUND.

All other signals should be connected as defined.

Signal

Connector Pin Cable Pin Cable Pin Connector Pin Signal

GROUND 1 1 2 35 -dB(12)

GROUND 2 3 4 36 -dB(13)

GROUND 3 5 6 37 -dB(14)

GROUND 4 7 8 38 -dB(15)

GROUND 5 9 10 39 -dB(P1)

GROUND 6 11 12 40 -dB(0)

GROUND 7 13 14 41 -dB(1)

GROUND 8 15 16 42 -dB(2)

GROUND 9 17 18 43 -dB(3)

GROUND 10 19 20 44 -dB(4)

GROUND 11 21 22 45 -dB(5)

GROUND 12 23 24 46 -dB(6)

GROUND 13 25 26 47 -dB(7)

GROUND 14 27 28 48 -dB(P)

GROUND 15 29 30 49 GROUND

GROUND 16 31 32 50 GROUND

TERMPWR 17 33 34 51 TERMPWR

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 83 84

Keine Kommentare

Hp NetRAID 1 Controller Bedienungsanleitung Seite 69